McGaughys 52459 7-9in Lift Kit - Black | 2020-2024 Silverado/Sierra 3500HD

Upper Control Arms #52414 (not included with kit)

Traction Bars #52420 (not included with kit)

Torsion Keys #52410 (not included with kit)

Rear Lift Shims #52361 (not included with kit)

Upgraded Front Reservoir Shocks #1102 (not included with kit)

Upgraded Rear Reservoir Shocks #1103 (not included with kit)

Front Reservoir Shock Mounts #52357 (not included with kit)

Billet Ball Joint Cap for Upgraded Upper Control Arms #51052 (not included with kit)

Billet Face Plate for Front Crossmember #51041 (Black) / #51043 (RAW) (not included with kit)

Billet Face Plates for Compression Struts #51441 (Black) / #51443 (RAW) (not included with kit)

Billet Face Plates for Traction Bars #51341 (Black) / #51343 (RAW) (not included with kit)

This kit can be adjusted to 8" or 9". You will need Torsion Keys #52410 (sold separately), to raise up the front. You will also need the Rear Lift Shim Kit #52361 (sold separately), to raise the rear up.

---

If running this kit at the 9" position, we highly recommend using Upper Control Arms #52414 (sold separately) to help with bump stop clearance issues

PLEASE NOTE: If you are installing the optional rear shims and rear traction bars, you may need to get longer u-bolts than what come with the kit. This is most common on 3500 trucks when installing all the rear shims along with rear traction bars.

Over-sized tires and heavier wheels can cause premature wear on factory and aftermarket components like ball joints, bushings, tie-rod ends, wheel bearings, idlers arms, drive-lines, etc…  You may need to replace / install new components sooner than factory recommendations based on the wheels and tires you choose. Please note that the heavier and wider wheels and tires combined with aggressive driving (off-road and on highways) will cause more wear on ALL moving parts, factory and aftermarket. Especially when vehicle is in 4wd or Auto-4wd / AWD modes. 

---

Spindles and u-bolts are shipped with protective coating on surface. This allows them to be delivered to you without rust. We recommend you clean and paint the parts before you install, to protect against any future rust. Remember, spindles and u-bolts are bare metal. And will rust without paint.