Zone Offroad D18 5in Coil Spring Lift Kit - 4in Rear Axle | 2010-2013 Ram 2500/3500 4WD

• 100% bolt-on design for easy installation.
• Bump stop extensions properly limit up-travel, protecting your vehicle.
• Heavy-duty upper and lower control arms improve strength and articulation while correcting caster.
• Heavy-duty front track bar bracket correctly positions front axle under vehicle
• Steering components included to ensure smooth post-installation operation of steering system and factory-consistent vehicle handling characteristics.

Description

• 2010-2012 Dodge Ram 3500 4WD
• 2010-2013 Dodge Ram 2500 4WD
• Fits models with 4" rear axle

• Front Lift Height: 5"
• Rear Lift Height: 3"
• Front Lift Method: Coil Springs
• Rear Lift Method: Cast Blocks
• Lift Type: Lift Kit
• Wheel Size: 17 x 9
• Back Spacing: 5"
• Max Tire Size: 35 x 12.5
• Wheel Size 2: 18 x 9
• Back Spacing 2: 5"
• Max Tire Size 2: 35 x 12.5
• Wheel Size 3: 20 x 9
• Back Spacing 3: 5"
• Max Tire Size 3: 35 x 12.5
• Finish: Powdercoat
• Cutting Required: No
• Accommodates Factory Wheels: See Notes
• Welding Required: No

• Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2” taller ride height, so net lift gain will be 3” over stock.
• Check Rear Axle Diameter: This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
• Factory wheels fit when paired with factory / original equipment tire size.
• Fitment: This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
• Gas Engine? Gas models may sit slightly taller than the advertised lift height due to lighter weight of engine.
• Lift Block Selection: These trucks are typically between 1" and 3" tail high from the factory. Please measure your trucks factory front-to-back ride height and order the rear lift height to achieve the desired stance. If closer to 1" tail high from the factory order the 5" rear coils for a more level stance. If closer to 3" tail high from the factory order the 3" rear coils for a more level stance.
• This truck was produced with different rear axles. Be sure to measure the diameter of your rear axle before ordering.
• Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.

• Dodge 2500 4.125in Rear Block Kit (ZOND1407)
• 10 Dodge Ram 2500/3500 5in Box Kit (ZOND1504)
• Dodge Coil Kit (ZOND3501)